New Microwire Configuration...

Our latest laser cut microwire arrays(Omn1010) have one location each to connect needed ground and reference wires. Because the reference and ground are shorted together in our RA16CH chronic headstages (unless the jumper is cut by the user) only one wire will be needed for most cases.

Important note! The solder pad is located on the back side of the microwire circuit board.

front view	back view

The illustrations above show a single wire connected to the ground pad located on the backside of the array.

Caution! The microwire array can be damaged by extreme heat. Use caution when soldering.