Tucker-Davis Technologies Electrode Specification Form


	Home	Products	Downloads	Support	News	About TDT	Contact Us	Search This Site

Omnetics Connector Based Electrodes

Customer Information

Electrode Spacing

* Required Fields

175 µm	350 µm
250 µm	500 µm

Row Separation

500 µm	1500 µm
1000 µm	2000 µm

Land Spacing

Tip Angle Specification

Blunt Cut (0 degrees)

30 degrees

45 degrees

60 degrees

Optional Attached G/R Wires

Wire Diameter (All Sites)

Ground

Reference

33 µm

50 µm

Only one wire is necessary for TDT headstages

Quantity

Enter the desired quantity of microwire arrays


	Tip Length Specification

Please select the maximum number of Rows desired	Default is 2 Rows - 16 Channels all the same length (2 mm)
1 Row - 8 Channels
2 Rows - 16 Channels	Specify tip length from last selected land (Maximum length depends on selected lands)
4 Rows - 32 Channels	O	= Omit shank (removes electrode at this position)

Microwire array channel numbers do not match the headstage pinout (refer to the headstage pinout for more information). Row 2 (channels 16 - 9) on the headstage pinout maps to Row 2 (channels 1 - 8) on the microwire array form below.

Row 1

Use for all

Check here if all lengths are the same

Row 2

Check here if all lengths are the same